How does a waterfall display work?

How does a waterfall display work?

Author: Onno (VK6FLAB) May 19, 2018 Duration: 3:20
Foundations of Amateur Radio

With computers becoming more and more ensconced within the confines of our radio shack the variety of information available is increasing regularly. The introduction of a waterfall display has dramatically simplified the process of detecting what the activity level is on a particular band.

If you've never seen a waterfall display, it's often a real-time, or nearly real-time display of radio activity. Leaving aside the mechanics of how this comes about, or how much you see, generally it's presented as a picture that changes over time.

In reality it's a very compact way of showing a lot of information.

You can think of it as a chart, showing the horizontal axis as frequency, the vertical axis as time and the colour as signal strength. So as you look from left to right you'll look at higher and higher frequencies. For example, the left side might be 7 MHz and the right side might be 7.3 MHz. Halfway along is 7.150 MHz.

Similarly, now, as in zero seconds ago is at the top of the chart and 1 minute ago is lower. Depending on how fast you've set it to update the whole screen might represent 10 seconds, 10 minutes or 10 hours of information, entirely flexible, entirely configurable, entirely arbitrary.

If you think of the colour black as having no signal strength and the colour red being maximum signal strength, then the brighter the colours, the more signal there is.

A morse code signal might turn up as a series of dits and dahs running down the screen, with the oldest one being at the bottom and the newest one at the top.

An AM signal might show up as a thick line with a bright colour, that's a high signal strength in the middle and lighter colours or low signal strength towards the edges.

Every mode has its own visual characteristic and there are even modes that allow you to read information within a waterfall display.

One of the other things you'll see in a waterfall display is strange artefacts, things like a diagonal line for example.

If you think of what a diagonal line represents as a radio signal, it's something that has a strong signal at a particular time and frequency. A moment later it's changed frequency and a moment later it's done it again. The steepness of the line is dependent on two things, the speed that the frequency changes and the speed that the waterfall is updating.

Before waterfall displays, the way you'd experience such a signal would be something that flashes up as a low to high swoop, or a high to low swoop, depending on your listening mode and the direction of the frequency change.

So what is that signal?

Well, it's likely to be something called an Ionospheric Sounder. It does what you think it does. Ping the ionosphere across multiple frequencies. The station doing this is listening for a return echo to see if the ionosphere is reflective for that particular frequency at that particular moment. The information can be used to create a map of what the ionosphere is doing right now, which in turn is used to figure out what frequency to use to make a contact.

I should also mention that there is a signal identification wiki which shows and plays various identified and unidentified radio signals, hours of fun for the family.

I'm Onno VK6FLAB


For anyone curious about the crackle of a distant voice emerging from the static or the thrill of making a contact across the globe using nothing but radio waves, Foundations of Amateur Radio offers a friendly, steady guide. Hosted by Onno (VK6FLAB) from Australia, this long-running podcast acts as a companion for newcomers navigating the initial, often overwhelming, steps into this vast hobby. Each episode deliberately unpacks a single facet of amateur radio, breaking down technical concepts, equipment, and operating practices into digestible pieces. You'll hear practical advice on how to get started, find your place within the global community, and discover which of the hobby's countless avenues-from building antennas to satellite communication or emergency service-might spark your passion. It’s not about dry theory; it’s about demystifying the process and sharing the genuine rewards that keep enthusiasts engaged for a lifetime. Having evolved from its earlier incarnation in 2011, this podcast builds from the ground up, week by week, creating a solid resource that grows with you. Tune in for a down-to-earth conversation that makes the airwaves feel a little more accessible and a lot more inviting.
Author: Language: English Episodes: 579

Foundations of Amateur Radio
Podcast Episodes
Building a shack: Part 8 - Will it ever end? [not-audio_url] [/not-audio_url]

Duration: 3:45
Foundations of Amateur Radio Building a shack makes a number of assumptions about your situation and to make it abundantly clear, it's not the only way to enjoy the hobby of amateur radio. Visiting clubs locally and remo…
Building a shack: Part 7 - Powering your shack [not-audio_url] [/not-audio_url]

Duration: 8:15
Foundations of Amateur Radio On your amateur radio journey, you'll likely discover that many transceivers run on 13.8 volt DC, give or take. For example my FT-857d requires 13.8 volt plus or minus 15 percent, with a nega…
Building a shack: Part 6 - Noise [not-audio_url] [/not-audio_url]

Duration: 8:05
Foundations of Amateur Radio Noise la la la la la hinders if I were a rich man effective a noise annoys an oyster communication but a noisy noise annoys an oyster more. Or said differently, when you're trying to communic…
Building a shack: Part 5 - Antenna Shenanigans [not-audio_url] [/not-audio_url]

Duration: 5:40
Foundations of Amateur Radio Putting your station together is best described as a juggling act, since you'll discover that everything depends on everything else and the more you plan, the more you learn and the more vari…
Building a shack: Part 4 - coaxial cable alternatives [not-audio_url] [/not-audio_url]

Duration: 5:55
Foundations of Amateur Radio When you start the process of getting your hobby off the ground, either for the first time, or after a hiatus, you might be left with the impression that the only way to "do amateur radio" is…
Building a shack: Part 3 - the ingress of coaxial cable [not-audio_url] [/not-audio_url]

Duration: 9:40
Foundations of Amateur Radio One of the potentially trickier aspects of putting together your shack is connecting the radio to the antenna. On the face of it, the challenge is limited to making sure that you have mating…
Building a shack: Part 2 - How much space do you need? [not-audio_url] [/not-audio_url]

Duration: 7:27
Foundations of Amateur Radio When you start on the journey of putting together a shack, in whatever form that eventually takes, you'll need to figure out how much space is required. Of course, no matter what you choose,…
Building a shack: Part 1 - Setting the Scene [not-audio_url] [/not-audio_url]

Duration: 7:21
Foundations of Amateur Radio Recently it occurred to me that I haven't been using HF in my shack for much longer than I'd care to admit. Over the years I've spoken about my shack and how it's set-up, more on that shortly…
Bald Yak 14, choices and software flexibility [not-audio_url] [/not-audio_url]

Duration: 8:19
Foundations of Amateur Radio Let's start with an observation, I'm a geek, have been all my life. Since my early teenage years that evolved as a predilection for computing. As you might already know, I became a radio amat…
I have a problem .. with logging. [not-audio_url] [/not-audio_url]

Duration: 8:45
Foundations of Amateur Radio The first step in solving any problem is recognising that there is one. In my case the name of that problem is "logging". Specifically the storage and collection of my amateur radio contact l…